Reply To: Complete Installation Instructions

Home Forums AR Sandbox Forum Complete Installation Instructions Reply To: Complete Installation Instructions


Dear Oliver

First of all I would like to thank you and appreciate your sharing of information

I having a problem after I installed the Sandbox and run through the calibration …. when I run the program using the command

./bin/SARndbox -uhm -fpv

my sandbox covered with water even after I changed the plain equation z coordinate as you showed in the video by making it lower than the lowest value of the four fixed point of the 3D points

notice that my BENQ projector could not cover my entire sandbox ( part of my sandbox not covered with the projector light) so I minimized my sandbox width so the projector could covered it all… but still the water level is above the sand and I can’t take it down under the sand surface

what would be the problem ?

Thanks in advance

Comments are closed.