CalibrateProjector Issue

Home Forums AR Sandbox Forum CalibrateProjector Issue

  • This topic has 1 reply, 2 voices, and was last updated 4 years ago by Anonymous.
Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #103574

    Good evening,

    This is my first post to the forum.

    I am having a problem at the last calibration step and would greatly appreciate any help I can get.

    The utility runs, as expected… A flash of red and then the cross-hairs appear
    I assign a key to capture the screen.

    The problem arises when I attempt to capture my first data point. The circle projection is not green, but yellow and it is being projected in roughly the same position I am trying to take my 1st data point.

    I would be most grateful for any help and suggestions.

    Thank you



    I registered on the forums to say I am having the exact same issue – I figure I missed a step but yes my color is yellow and the calibration cross does not move.

    Also thank you for the very detailed instructions and video!!

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.

Comments are closed.