calibration points below sand surface

Home Forums AR Sandbox Forum calibration points below sand surface

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #102383
    UWYOPedology
    Participant

    I can’t seem to get it to register a disk-height below the sand surface when calibrating the kinect\projector. It starts green but turns yellow as you approach the sand surface (< 1″). When I run the program using the calibration from points only above the sand surface, there is misalignment of the topo lines and the surface (especially below sand surface) and it appears to be worse as you move to the sides of the box. Seems similar to the effect when you don’t pass the -fpv switch when starting the program, but I am thinking it is because I can’t get any calibration points below the surface. Thoughts?

    Thanks,

    Rob

    #102384
    UWYOPedology
    Participant

    Never mind……just needed to watch the YouTube calibration video a little more closely.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.

Comments are closed.