Calibration – sudden boundary change

Home Forums AR Sandbox Forum Calibration – sudden boundary change


This topic contains 1 reply, has 1 voice, and was last updated by  fnoigy 1 month ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #118871


    I’m using v2.6, everything is fine up until the calibration step with the disc. When doing this, the calibration program can’t see the disc when I put it under the first crosshair. It will only start detecting objects when they’re a full foot or so into the table area. All other steps worked fine, and were able to see and get depth readings well outside the boundaries of the table, so I’m not sure why this step suddenly can’t see the whole table.

    Is it possible I messed up the BoxLayout step? I’m also not sure if that file needs to have a .txt at the end (I’m used to MacOS and Windows occasionally hiding extensions mercilessly).



    NEVERMIND! I didn’t realize that BoxLayout.txt had to go into a folder called SARndbox-2.6 within the “etc” folder WITHIN a higher-up SARndbox-2.6 folder. Found the default, replaced it with mine, all is well. Don’t make my mistake! Pay attention more carefully to paths!

    • This reply was modified 1 month ago by  fnoigy.
Viewing 2 posts - 1 through 2 (of 2 total)

The forum ‘AR Sandbox Forum’ is closed to new topics and replies.

Comments are closed.