missing separator character

Home Forums AR Sandbox Forum missing separator character

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #101218
    pkhutch
    Participant

    After putting the equation and the four corners into the Box Layout we’re getting this error message: Terminated Calibrate Projector due exception::unable to convert “the equation” to Geometry:: plane due to missing separator character.

    any thoughts?

    #101219
    daparret
    Participant

    When populating the boxlayout file, did you by chance improperly copy over the camera-space plane equation?
    It may be that you missed the step where you remove the equal ‘=’ and replace it with a comma ‘,’.
    If that is not the issue, could you post your current boxlayout file?

    #101221
    pkhutch
    Participant

    Thanks. did copy the equation correctly, but did not replace the = with a comma. I paused that video a hundred times and didn’t see him do that! How did you figure that out?

    #101222
    daparret
    Participant

    In your error code it read, “unable to convert “the equation” to Geometry:: plane due to missing separator character.”
    The separator it was looking for was that comma. Also, the only plane equation requiring modification during that step was for the camera space. So just some lucky elimination. Glad I could help.

Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.

Comments are closed.