Plane capture

Home Forums AR Sandbox Forum Plane capture

Viewing 1 post (of 1 total)
  • Author
  • #102381

    We’ve re-configured our ARS’s plane projection and have been unable to get the image to fit within the confines of the sandbox; it falls short by about 5cm across one side only. It doesn’t appear to be a projector problem (we use the recommended Benq projector) since it shines to the edges of the box. It would appear that the Kinect is not reading this part.

    Any suggestions? The box projector file is below. We’ve tried adjusting the x-values to compensate,but to no effect. Should we try adjusting a different value?


    (0.0527991, 0.00571654, 0.998589), -94

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.

Comments are closed.